NewTechWood Composite Fence Panel

What can I use these composite fence panels for?
The NewTechWood Composite Fence Boards are designed mainly for fencing. However they are also suitable for screening, cladding and feature wall applications, both outdoors and indoors. The 2.7m length and lightweight profile make it adaptable to most standard residential projects.

What screws should I use to install the boards and trims?
The type of screw will largely depend on the material of the batten you're fixing the fence boards to. Please refer to the installation guide for specific information.

Do I need a tradie to install these panels?
No. The panels are specifically designed with competent DIY users in mind. The click system is straightforward and the boards are lightweight enough to handle solo without any specialist tools. Standard stainless steel screws are all you need alongside the panels themselves.

What tools do I need for installation?
No specialist tools are required. The panels can be cut with standard woodworking tools and fixed with ordinary stainless steel screws. A tape measure, saw, drill and level are all you'd typically need to install the fence panels themselves. keep in mind, if you're building an structural fence other tools will be required like post hole diggers, cement, etc.

Do I need to paint, oil or seal the panels after installation?
No. The panels come pre-finished with a protective coating applied during production, so they're ready to go straight out of the box.

How do I maintain the panels once they're installed?
Maintenance is minimal. An occasional clean with soapy water and a soft brush is enough to keep the panels looking their best. Because of the protective coating, there's no need for periodic sanding, oiling or resealing the way you would with timber. If left outside, the occasional rain will wash most dirt off leaving you with next to no need to wash them by hand.

Are these panels suitable for Australian outdoor conditions?
Yes. The panels are built with UV protection to handle harsh Australian sun, including coastal environments. The composite construction resists the warping, cracking and fading that affects timber in Australian conditions over time.

Can I use these panels near a pool or in a coastal area?
Yes. The UV-stabilised, pre-finished surface handles both poolside moisture and coastal salt air without corroding or degrading. Unlike timber, there are no ongoing treatment requirements to maintain the panels' resistance in these environments. Make sure you choose the right fasteners for your environment.

What are the panels made from?
The NewTechWood Composite Fence Panel is made from 95% recycled materials. Each board has a protective coating applied during production that gives it its UV resistance, low-maintenance finish and long-term durability.

How long are the panels and can I cut them down?
Each panel is 2.7m long, which suits most standard residential fencing projects. The panels can be cut to length using standard woodworking tools.

Can I use them for interior feature walls as well as outdoor projects?
Yes. The lightweight profile and pre-finished surface make these panels just as suitable for interior feature wall applications as they are for outdoor fencing and screening. The composite material doesn't let off any unpleasant smells or require ventilation.

How do these panels compare to a traditional timber fence in terms of cost over time?
The upfront cost of the NewTechWood Composite Fence Panel is designed to be accessible and competitive with standard timber options. Where the real difference shows up is over time. Composite panels don't need sanding, painting, oiling or board replacements the way timber does, so the ongoing cost of ownership is significantly lower.